Who knows how to program a 2000 Grand Prix Key fob? I looked up something last night but it doesnt seem to work…
maybe im just not doing it right? I dunno
post pics of said car…
hood rich right there!
looks exactly like mine, except for the street glow stickers
The side windows adds 15hp the big one ads 40hp
this might help you
on the new GP’s you are unable to reprogram the Key fob. you must bring it to the dealer…UNLESS…you have a OBD II scan tool. if you have access to one, then here is the process…
Transmitter Programming:
Important: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.
-
Install a scan tool. Use the scan tool in order to access programming: Vehicle Control System/Computer Integrating System/Module Setup/BCM/Program Key Fobs. Press the START soft key on the scan tool. Important: The scan tool must stay connected until all of the transmitters are programmed.
-
Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of 5-10 seconds, the scan tool will indicate that the transmitter is programmed.Repeat the previous step in order to program up to 4 transmitters.Remove the scan tool.
Operate the transmitter functions in order to verify correct system operation.
Okay…
I looked up a few methods that said you had to pull the
Mall PGM Fuse
Then turn on acc
turn off and then back on acc within 1 second…
Open the drivers door
then press lock and unlock…
And just a noram OBD II scanner like that I could borrow at advanced for 5 minutes
well this is saying you just hook up the scanner and hold both lock and unlock on the remote until it says program complete. there might be another way but this seems easier.
