Albany Speed Shop / Krazy Kid Kustoms 2004 Jetta Track Car

[votblindub]

@KrazyKid

Going rwd with it. the rear end will come out of a Gen1 Quattro, with vac locking dif.

the plan for the motor is to spin it 90deg and mount it with a 1/4" thick aluminum front plate and mid plate to some L brackets welded to the frame rails.

Want to put a T5 behind the motor and get s custom drive shaft done to mount to the Audi flange on the read diff.

Quicktime performance is working on a 1.8T to t5 bellhousing, release date is TBD.

My idea was to machine a plate that would mount to the motor, a plate that mounts to the t5 and use 1/4" steel plate to fill in the middle. Which would also qualify as a scatter shield I believe.

Mount the 1.8T 228MM dia flywheel to the crank, find a 228mm or so clutch disk with the t5 input shaft splines, put that between the 1.8T pressure plate, and run a hydro throughout bearing unit inside the housing. Get all the components sandwiched in place in there then jig the block and transmission in place and complete the bell housing.

what do you think?

i think i have no idea what that means except the first line and that u’ll need to explain that mess to me :lol:lol