In related videos… LOL
$338 for big turbz :rofl
lets see how it goes right!
you’ll be bored with the car by the time its no longer cost effective to replace the turbo.
dats true.
If i get straight sections of 2.5" 304 who is a good exhaust co that can make me some MSC bends without being douchebags? Just chalk it up in the mandrel bender and make a bunch of J bends for me?
$30 for a 180 U bend is like $20 a bend! thats retarded. Shits $10 a foot straight.
Good luck finding a place with a mandrel bender.
I thought bway and those guys had mandrels up to 2.5" anything past was crushers.
No one has a mandrel bender that I know if in the 518. The smaller diameter pipes take to the standard “crush” bend a little better.
Pie cuts ya pussy
whitey bends as the H-T guys call them.
PT46mm on its way, flanges and tubez too
you wanna do all that filing and tigging!?!?!? :crackup
fuckkk that im just going to get a 2.5" msc bend kit and have lots extra for other work.
I’ll mig some byrdshyt welds for ya :rofl
are you gonna tub the rear?
your out of your mind with this project LOL
dont need to. The wheels I have on it now for mock up are 29X11.5’s and fit right under the rear fenders, I cut some of the un needed brackets and little tabs off that arent needed and the inner fender is gone, but the 28X10.5 I want to run should have more than enough room. :rofl
vouching for birdshit welds. thats an accurate statement.
WHERE ARE THE FUCKING PICTURES MIKE!!!
BIRD. SHIT. WELDS.
Dave Ill bring the camera out tomorrow and get some pictures finally.
i wanna see this! and kevins truck too, havent been up there in a while
page 18 or 19 irc.
I am headed down tonight to swap nuckles and see how the rack will fit ill snap a few then too.
werd. I am off to mexico next week for a week, so when I get back lets meet up.