An idea I am working on... help would be appreciated...

[imported_Hero]

What is the problem with the LED lights? I’ve seen them on several vehicles, have commented on the smooth, install to the owners, and they have never had any problems with the fuzz. The cleanest install was on a Jeep CJ.

Is your plate in one of those back windows that has it molded in? I recently saw one of those on a full size Chevy and it really cleaned up the entire back of the vehicle. Not sure if it was lighted though…

So you want this thing to lay flat in the bed and then tilt or slide into position above the existing rear gate?

[S10Blazed_Si]

@Sight N Sound

Looks good and its pretty cool, only problem I see is two things the cops are still going to harrass you about. First is it doesn’t look like you a plate light which will give them reason to pul you over and harrass you. Especially because of how unique looking that is.

Second they may say the lights are mounted too high for the vehicle. Lights have to be mounted within a certian distance according to bumper height.

Just food for thought.

Thanks for lookin out for me but I have license plate lights. The bolts for the plate have LED lights in the heads. Pretty nifty little things. I bought them at Summit but can’t find them on their website.

I have plate location just fine - http://www.pacode.com/secure/data/067/chapter47/067_0047.pdf

Here is the code reguarding the tail lights. I read it before and recall reading height requirements but skimming through it again i didn’t find it. - http://www.pacode.com/secure/data/067/chapter153/067_0153.pdf

Hero - my LEDs do not have any reflective backing. If you want to get technical, they aren’t visable from the side either. I caught a lot of flack when I just had them in. So far so good on the current setup :bigthumb: