BIG REDS wanna be Nick Cage Build thread.

looks so much better not all 4x4

SEXXXY

Looking better all the time man, when are you gunna jump it over the bridge?? :haha

Very nice man

WTF is up with no snow on the ground? Lucky bastards…
The stance is looking good!
Did you say you had the “Go baby go” button too?

it still needs more low, I gotta add another 1/2 in block to bring the back down more. and the front ill be able to get perfect with coilovers. the car should tuck tire all around.

this is where I gotta get to.

i actually like the stance on yours better

This…

Looks kinda funny for a 60’s mustang to tuck tire.

nah in person it needs you can tell it needs to be tucking a tinyyyy bit, dave knows what he’s doing it’ll look 100% when he’s done

ima kick you in the nuts

this

so after tearing the center section out of the rear end for the third time, I found that the pinon which I bought brand new was defective, the front of the pinon was out of round and there for when I put load on the car it shifted my backlash causing the ring and pinon to bind and destroy itself. So after a phone call to jegs yesterday I had a brand new ring/pinon and bearing/install kit show up on my door step free of charge.

http://img34.imageshack.us/img34/8071/img3437o.jpg

after a few days of sitting the rear leafs finally settled they advertise a 1.5 in drop over stock which was about right, I already had a 1 inch lowering block in addition tot eh drop leafs and I decided it wasn’t low enough, my pinon angle was also off. So I made my own lowering block with the correct pinon angle out of billet aluminum. This will not only give me the correct pinon angle but also lower the car another 1/2 in or so in the rear. big thanks to ron at rhino racing for machining these for me LOL

http://img843.imageshack.us/img843/5959/img3431y.jpg

in comparison to the 1" block I was running

http://img153.imageshack.us/img153/545/img3432pw.jpg

http://img576.imageshack.us/img576/7138/img3433u.jpg

perfect fit

http://img29.imageshack.us/img29/8299/img3434t.jpg

although the car is still on jackstand this should be about where it will sit, just barely tucking a little tire.

http://img812.imageshack.us/img812/7449/img3435va.jpg

http://img339.imageshack.us/img339/6268/img3436i.jpg

pick up your damn tools!

Do not make the Sarge get loud again

oh sorry the 1 tool I was using 30 seconds before the picture was taken and was used again 30 seconds after…

I doubt he’ll accept your apology

nope.

Sarge is not pleased.

This is not going to go over well with Gloves

That thing looks better and better everytime I see pictures! Great ride!