klemann will do anything to get me to fill a hole :gay:
Denton: The plastic welder i have actually melts the plastic as I add a filler rod of similar plastic, just like regular welding (minus shielding gases)
ghettostyleTA: Clear bra is super easy over surfaces that are conmplex or have complex curves. It doesn’t stretch very well, so you usually need to make relief cuts or chose how to cut your 3M pieces (if you don’t buy them pre cut). Basically use lots of Alcohol/water mix to keep the adhesive lubricated until you get it posistioned. Squeegie the air bubbles out and, set it…and forget it.