[quote=“Shockwave179,post:6,topic:26744"”]
Looks pretty good for a drag cage, is that mainly what you guys do or ?
[/quote]
Chris only requested an 8 point bar for right now, so what you see is good until 9.99 in the 1/4. Since I dont think that will be a problem, it was built with upgrading to a 10 point cage in the future in mind. Also, we prefer to only use DOM roll cage tubing, as the ERW tubing found in most kits is not as strong. 6"x6" plates were molded to the floor as mounting points for the cage, the rear down bars are kept wide and mounted above the rear suspension, and the small cross bars off the main hoop increase side to side stability.
We made the seatbelt tabs, clearanced the wheelwells for the larger tires, installed the new steering wheel and will be mounting up the new seats. Ofcourse the engine work is just as interesting, but I’ll let him make you find out what it has
The mustang cage we are doing will have swingouts on both sides, and one of the fbody 10pt cages may have a passenger side swingout, but all of the cars getting bars/cages will be regular street drivers.
Any engine builds, fabrication, conversions etc that you have in mind, we want to do :headbang: