is there any mustang tuners local?

[pitman]

@KrazyKid

you could put a timing wheel on the motor, use a dial indicator on the pushrods and do the math and measurements… but the time it would take to do all that, and you already have the front shit off the motor and the valve cover, your 90% there to removing the cam… just remove it and check the serial number or id scribing.

your 100% going to want to know what cam is in there. 400whp on a 5-7psi V3 compressor is the upper spectrum of expectations even with GT40 heads, a decent cam and exhaust. with injectors and a well running tune on a 7psi pulley my moneys on 376whp.

Is this intercooled?

yes i thought you would have to measure a bit.

also some cam regrinding companies do not label the cams. so he could have a oem cam regrinded and he would never know unless he measured like you said or removed the cam and put it in a lobe finder.