Just installed my Stance coils from bing!

[logik23]

@a_ahmed

Looks fantastic. What did you have previously? How does it feel now (handling, dampening, ride comfort, etc…).

Awesome car.

Thx! Before I had 16x7 +35 4 bolt Rotas with the same tires I have now and Kei Office coilovers, but they blew out, which is why I switched to Stance. Never again will I buy used coils. lol

@bing

Make sure you hammer up the seam above the front wheels in the fender-well area.

also, you need to relocate your wiring harness on the drivers side. you can lift it up and hold it with zipties tight to the top of the fender or you can really pull it out and tuck it between the fender rail and the inner fender above the wheel.

if you dont do either of these things, being that low, you are going to cut your tires on the metal seam and melt your harness causing significant electrical issues.

I’m actually goign to do all the necessary tweaks in the front before I drive it any more. I just had to get home last night which is why I drove it the way it was. I heard it rub everytime I went over any little bump and smelled burned rubber sometimes. lol

@Lith

make sure you get a proper alignment done after you find the front/rear height you like. Otherwise the car will feel odd and you’ll probably waste those tires a lot sooner than expected. I don’t think you’ll be able to do anything with the camber in the back though… unless you have the RUCA’s and the toe links.

I will!