That mesh is strong shit. Its like 3/16th thick itself. Metal Supermarket built a low-boy trailer with it and they spaced the supports 2 foot on center and it holds heavy equiptment just fine. We ran the ramp over as you see it with CRD’s F250 5.4L… it didnt deform at all. :thumbup
They can still pivot a bit. the edge of the ramp to the trailer bumper is around 1/4" when its pinned. the only movement that would upset the fitment when it loads or unloads would be suspension flex, and that would only drop the bumper a few inches tops. If the bed angle changes enough to bind the ramps up, I am going to have a BIG dent in the truck’s tailgate casue that ment the hitch came loose! We also thought of 2 camper jacks out back, so keep the bed from lowering at all. that way the truck’s hitch and the axles and the rv jacks would keep the bed inplace perfectly. but i think it might be over kill at this point