Pics of my 3rd Gen. LT1 project

Builds
1

Here’s a few pics I took this weekend when I was getting the LT1 into the camaro. Progress is going good so hopefully it’s done by this spring.
http://www.pittspeed.com/uploaded/Pic1.JPG
http://www.pittspeed.com/uploaded/Pic2.JPG
http://www.pittspeed.com/uploaded/Pic3.JPG
http://www.pittspeed.com/uploaded/Pic4.JPG

2

Nice Third Gen bud!

3

Thanks, I put a lot of time and money into it haha, so i hope it turns out nice when it’s all done.

4

looking good man, cant wait to see it in person. do some grudge racing this year, thirdgen vs thirdgen haha :slight_smile:

Whats all done to that LT1? I should have done that swap earlier this summer but instead i went with a stealth ram intake and some other small stuff.

5

looking good bud…keep the pics coming

6

cool man

7

i love 3rd gens

8

looks good

9

wanna race?

10

to much red

11

Your sig is huge. Please make it reasonably smaller.

12

um… its bored .040", SRP forged aluminum pistons, LT4 hot cam kit, 58mm BBK, ported heads/intake, electric water pump, 30# SVO injectors, Hooker Supercomp. Long Tubes, T-56 6spd, and i got a delteq coil kit instead of the opti. Thats about it. I look forward to the racing this summer hahaha. and thanks for the comments.

13

aww should have stuck a real cam in there ! haha should be a nice street car tho. i wish i had a T56

14

nice it looks good

15

Heres a pic showing my custom crossmember i got from spohn performance… what a difference from stock!
http://www.pittspeed.com/uploaded/untitled4.JPG

16

yeah spohn makes a NICE beeeefy piece. Kinda sucks for exhaust clearance, if you plan on running longtubes and a ypipe of some sort

what are you doing for exhaust?

17

looks good ben i see your treating my old lt1 motor good bud

18

thanks guys, um… exhuast wise, I’m planning on going to see jeff at first try. I like the way you ran your exhaust Orr89, so as of right now i think i’m planning on going with that and having an SLP loudmoth muffler in the run of the pipe before the axle and splitting over into the two tail pipes like you did. I’ll also have him fab me up a custom y pipe.

19

i’m redoing my exhaust since i’m goin with a new motor and long tubes… i want to try to reuse my existing rear exhaust section and just run true 3inch duals but only if i can run a xpipe and mufflers where i have the powerstick now. if i dont reuse my setup, i’ll be selling it :slight_smile:

20

lookin good