well it was a nice day out today so i installed my wheel spacers. they are 1/4 inch and to my surprise they look really good i didnt think i would notice the differnce. but they flush the wheels out better then before.
opinions and comments welcome…
Brent
before
after
Much better, I need some also.
Looks almsot perfect to me…just enough so you don’t rub.(well for people like me who aren’t going the coilover route.)
Where’d you get them from and what offset are you running?
What Stud’s are you using with these spacers?
I hope not Stock…
Locknuts wrapped around 1 thread, :lol:
could use another +20mm but its better than my oem and better than before :lol:
i was thinking the same thing.
what did u use
i’ll be needing 10mm’s for my car, what do ppl recommend?
yeah not enough !! 1/4" nah should have went 1" would look like this…
the spacers are a set of aluminum ones i got a local performance shop they cost me 8 bucks a peice i like the look much better. i took them of already because i still have stock studs. i need to get aftermarket ones. unless you guys think i can get away with the stock ones. there is about half maby a big more of the lug threaded on. it is a concer to me to…
Brent
u need a set of hubcentric adapters to properly space out your wheels safely.
1/4 inch is like 6mm which is about as large as you are going to want to go without longer studs, it may infact be pushing it.
are the rear studs longer than the front one?
i think i read that somewhere but i cant remmeber where
ya i think they are a bit longer… i just got back from westside performance shop. and talk to there guys. they said i should be ok. as long as you have at least 4 full turns or more then you will be ok i have liek 6-8 at least before they are snug so i think i will be ok… i am worried if i get to long of studs i will need new lugs and wheel locks…
BRent