:spank:
i see those heads are now junk. look at the hole you created by going to thin around the pushrods. LS1 heads are tricky to port unlike old school heads and should be left to the pro that uses a flow bench. theres only certain areas where you need to remove material
Awww snap. I guess I suck at life.
You better do some research on lsx’s before you step next time sucka! This one is to easy to own you on.
shoot…
well, I said I wasn’t. But what the heck.
Its the rocker stud bulge. Its commonly practiced to remove it and put some sealent on the rocker bolt.
These weren’t hard at all to port. Does that mean I’m a pro?
still went thru the head. junk that head start over and try not to go to far
[QUOTE=Domination;442248]well, I said I wasn’t. But what the heck.
Its the rocker stud bulge. Its commonly practiced to remove it and put some sealent on the rocker bolt. QUOTE]
what???