Nice wildcat.
I haven’t been to tall pines yet but I’d till like to check it out. With hunting season now here tall pines and majestic will be closing till its over. Spam and I are still planning on going to KB Sunday for the dice run.
Wait till I get the bumpers, roof, and lightbar on it.
Majestic does not close for hunting… We have a cabin rented for end of october.
Need to get renegade running uugggghhhh
Wtf… what happened now? thought it was all back together
Mine needs trailing arm bearings, and 2 boots replaced… aint nobody got time for repairing that! I’m itching to ride though
I’m getting good at them and have the special socket top do it.
I tossed out together with the old pistons, just to run it, I had to send the old ones out the have them fly cut to fit the valves. Front is done. Just have to do the rear
Oh and 
Nice I haven’t bought or done anything to mine since I got the motor back together. It’s been a year and a half and it’s still rocking hard. Runs great.
You need to redo your clutch…
Need to do something
I need seat time. I haven’t ridden the Rene all but 10 miles this year
nice man, do I spy a yellow yami back there? diggin the SX’s too. I had an 86 tri-z awhile back. Wish I kept it, been hard to find another since.
Anyone go to KB dice run? I thought I’d was this weekend not last.
We all said fuck that… Videos show it was a swamp and a jet ski would have been better suited
Anyplace I can get an atv dyno tuned?
finally got to rip on my blaster after the 2nd rebuild.
It fired up second kick and ran great the whole day. I need to replace the rear axle, its bent and the spines are screwed up. the sprocket and rotor are bouncing around.
What ended up being the issue at majestic?
You had to rebuild it again after I did it?
Check into a banshee axle. If I remember correctly it is a direct bolt on.
found out we cant tune quads on @turbocivs dyno. lol
Thanks again for trying, very much appreciated