RB 280zx project, suggestions?

[JVG]

@Johawk

All above are good shops. If BoxerSex Adam has down time I would jump on it tho. Last I knew the guys at ASS were open for a project too. All 3 have more than enough knowledge and experience to finish her up.

PS. Albany Drive Shaft said they would make me a brand new 3.5" aluminum shaft with over sized yokes for about $350-$400. A small steel one would probably be closer to $250
LS1 @ 4000rpm + Twin disk + DRs = twisted aluminum mess

Little late to the party. Boxersix is already dipping into this fine project