Well about 7-8hours to do start to finish. Then it rained like a bastard so I haven’t even taken a test run yet. I have some pics but there are install notes that are already done up on Twinturb.net for anyone thinking about doing the job themselves. It wasn’t that hard other than the extremely tight fitment in the stock locations. Signal harnes wiring mod required and a new harness was included in the kit. It just changes the bulb socket to a 90 degree instead. It still hits the cooler and I think to get the right air flow and fitment I am going the have to change my fascia eventually. I did not reuse my factory air guides, there were mixed comments about this but it would have been even a tighter fit with those in. So they are in my “removed” pile!
Well about 7-8hours to do start to finish. Then it rained like a bastard so I haven’t even taken a test run yet. I have some pics but there are install notes that are already done up on Twinturb.net for anyone thinking about doing the job themselves. It wasn’t that hard other than the extremely tight fitment in the stock locations. Signal harnes wiring mod required and a new harness was included in the kit. It just changes the bulb socket to a 90 degree instead. It still hits the cooler and I think to get the right air flow and fitment I am going the have to change my fascia eventually. I did not reuse my factory air guides, there were mixed comments about this but it would have been even a tighter fit with those in. So they are in my “removed” pile!