Any Chrysler Techs here at NYSpeed ?

[JUICEDSS]

see if you can check what code its throwing. on most chrysler cars, you can do it without a scanner. Put the key in, and turn the ignition on, then off, on, off, and on. Leave it in the on position that third, and last time. Where the mileage normally reads it will come up with the fault codes, and it will say DONE when its complete. Then look up the code on the internet.

That worked. PO700 is the code as was mentioned by the psycho. I’ll do a bit of research and see what else I can find…