Azn Dan's Camaro

[electronBLUESS]

@danhr

Already sold the ones from Brian’s TBSS. They were milled .045, which was just way too much for me. It gave a good compression ratio but cam selection wasn’t that great with PTV clearances. Not looking to flycut at the moment

Called up Rich at West Coast Cylinder Heads and told him what I wanted to do, and he gave me a few suggestions and was extremely helpful. My new set of WCCH l92’s are on the way now

If the cam u listed in ur one thread is the cam ur going with those heads would have worked. I put a much bigger cam in that 2010 camaro I did the heads and camswap to.