how do you know when your clutch is gone and not the slave or master cylinder?
-> right now gears goes in perfectly fine when off but won’t go in when on.
can’t see any leaks so would that be my problem? if i start it in first the car doesn’t jump, it sometimes creeps and sometimes it doesn’t move. lift up on clutch pedal and i can drive it normally.
any help?
ka24e, with de transmission, but its the same anyhow.
My car is doing the same thing, I can shift into first or reverse with the car off, but if it is running, it won’t go into 1st or reverse unless forced. It doesn’t grind gears when shifted into 1st or reverse, it just sort of pops into gear. This is in my 93 ka24de.
from my experience its not the clutch cuz ive burnt my clutch it still goes in gears but just ur car wont move. and usualy uno when ur clutch is going it starts sliping, check carefully for leaks on the clutch slave maybe u got air in ur system try bleeding. also check all the lines and clutch master cylinder.
try going under the car while some 1n presses the clutch see if u notice anything getting stuck or something.
Happened to my teg before. When you turn on the car in gear, does the car turn on and right off? (as if you stalled…)
It was my clutch disc.
i changed the master and slave already and bleeded the system, looking at the tube there’s no air coming out so i’m somewhat stomped.
and the car does not stall. sometimes it will want to creep forward as if you were trying to balance and sometimes it just stays put in neutral as its suppose to be.
I think your clutch is gone man .
bah de swap time.