Justin's s14 240Sx (94 sentra_xe)

[BlueS14240sx]

@Hooked on 240

id really like to know who bends installs, bends, installs, bends installs…

:rofl 6-8 EASY bends.

This goes for everyone…
you need:
tape measure
line
common sense
and a bending tool. and your done.

but for 12 bucks, its not that bad… lights dont look like there gunna fit. idc what dan/anyone says. until its done / mounted. i dont think they’ll look right. just found a couple pics of the lights on a s14…idk if others half assed it or what, but most of them dont seem to fit.

But i do love those lights… ALOT. :excited

yeah well, nobody is as JDM 240doriftotyte as you jeff

@ninety1two40"

I’m not feeling the lights, hope the look better than that when they are fully installed!

Where on earth do you get pre-bent lines for $12???

idk just going by what dan said i havent priced them out yet

@bennyfizzle

The headlights are wayyy too large for the front end, they’re meant for a car that’s a tad larger than that s14.

I think it’s going to look like poop.

thanks for the encouraging words, i made a post on NICO, Zilvia etc. about trading for R32 lights, they will fit and look MUCH better, RHD beams FTW!