i had to to pump the clutch to shift gears
i was told to change master clutch cylender
and i did.
i bled the the lines and now my clutch does this.
i pump it. it gets hard. i let it go for a bit.
and it just goes down like nothing there is no pressure in the clutch.
what could be?
Is the slave leaking at all
You should always change both slave and master together as they fail because of water contamination. So if one goes the other will go soon
But i bet you just did not bleed it properly
Or the pedal broke.
i read JoshB’s excellent Clutch Bleeding guide
and did all .
but
it might be the slave
i will change that and see whats up.
and the pedal looks fine to me.
and should i try removing the damper?
Even though the slave might look dry, pull the boot back and you may find it full of fluid.