Need Help Removing tranny. Need to do tomorrow early AM

Ok, couple technical questions. I am going to be trying to remove a transmission tomorrow in a junkyard and I need to know what I should be aware of.

First, the car is a 92 Lumina Z34 with a 5 spd.

Questions:

Do I need any special tools, for say removing the axles?

Once I unbolt the bell housing (and other visible parts) will the tranny just pull off the flywheel?

Will I need to drop the subframe, and if so, what size bolt should I be expecting?

Aside from the bellhousing bolts, and the mounts, are there any other points that hold the transmission on?

And technical help would be greatly appretiated. I am going tomorrow morning at like 9ish

no special tools required really. Pickle fork to help you remove axels.
once you unbolt the tranny (and starter) it will just pull off the motor however, you will probably need to lower the motor on the tranny side within the bay to wiggle it out. Yes you will most likely have to drop the subframe. It will probably be a 19mm to get those off.

on gmas theres a tranny bolf on the other side of the housiong thats a bitch its called the bolt that doesnt go back in