non-abs vlsd (manual) bolt to abs car (manual)??

[tosh]

@Jammin1911

maybe i should clarify

i understand that they are different lengths, but i also understand that when it comes to driveshafts lengths are not super presice and there is a bit of leniency as far as the spline engagement goes

if the diff that I have causes a bit less engagement at the tranny i dont really care if its only a fraction of an inch… i just have no clue how much of a difference there is or if the change in mounting position might fuck up the carrier bearing mounting point or what…

i dont want to get 90% in to the job only to realize i’ve been wasting my time, thats all

it will work as i have read of people that have done it. but i have also read that people also complained of excess wear in the bearing because of slight binding. get the right drive shaft, they are not hard to come by.

peace