spacer size help

hey i have a 1995 coupe and im run 17 x 7.5 rims with 225/45/17’s for rubber im looking to get spacers but not sure what size spacer to run, i have rolled my rear quarters but did not do my front fenders, i was thinking inch and a half spacers on the back and inch and a quarter on the front, looking for the flush look, any help or advise would be greatly appreciated.

use washers to get flushness. remove washers and measure. then go and purchase spacers to measurements

honestly, get new rims.

17x7.5 is going to have a FWD offset too…

you shouldnt be running 30mm spacers on a car… that’s like $600 in spacers to space out a set of $150 wheels.

go buy some better fitting wheels instead and use spacers to fine-tune the fitment not to unfuck shit wheels

sorry to bud in on this topic but what is a good fitment? i have a set of volks, 17x9 +20 all around, should i get 5 mm spacers all around to make it +15 offset? i have not rolled my fenders yet and plan on getting 255/40s in the rear and 235/40s up front,

fitment depends on ride height, alignment settings, tire sizes, wheels widths and offsets etc. etc.

least wheel gap without rubbing is good fitment

i would honestly love to buy new rims, only problem is i am short on cash and know a place i can get spacers for relatively cheap… and i just got brand new tires and just had my rims painted. new rims will come but for now i have to work with what i have

where is this cheap spacer place?

there is no such thing as a good cheap spacer that wont cost you a few hundred dollars for 30mm on all 4 corners.