OK, here are the pics from last night:
This is the factory skidplate, after I removed it:
And the grill and fog light surrounds:
Where did my bumper go?:
Right side:
Left side:
And here is the giant factory crash beam that I have to remove next:
The bumper, after I cut out the middle section:
I just did the basic cutting for now, here is the first section I removed:
It will look similar to this, but the IC will be higher, so it wont stick past the bottom:
Again:
The core is pretty huge!:
And its 3" thick:
Here’s a shot from behind, what it looks like:
Were both smiling 
:
This will go on tomorrow!:
Lets hope that it goes smoothly. I cut some more before I went to bed. It is really close to being done cutting, but now its at the point where I have to keep mounting the bumper, cutting where it hits, and repeating. :tdown:
–mark