boost creep sucks and the ecu i am using cuts fuel at 14.7psi
jancen
porting a wastegate is super easy. buy an air die grinder from harbor freight and a reaming bit for 15 bucks and DIY. Or take it to innovative.
.
X3
cast is a pain to port when you don’t have the right bits
really? I never knew that… O M G
:roll2:
A bit is $10 at harbor freight.
Or you can pay a shop labor to do it. Innovative was already mentioned.
yes i know this and both are located in north buffalo not the shortest drive your know
there are like three local HFs…
and you didn’t specifiy anything other then “buffalo,ny” as per your profile there.
Good luck.
cast steel is not hard to ream at all. get a ream, not a grinding stone. 10 bucks max.
do it yourself…go to harbor freight and buy a bit, you already have 35 cents all you need is $9.65!