I have 2 10’s that are 2 x 4ohm stable. I’m running a cheap 500wx2ch legacy amp. “model la770”.
Sub’s are bazooka 10’s dual-voice coil.
What is the best way to run a 2 channel amp into 4 channel inputs of the subs?
I have 2 10’s that are 2 x 4ohm stable. I’m running a cheap 500wx2ch legacy amp. “model la770”.
Sub’s are bazooka 10’s dual-voice coil.
What is the best way to run a 2 channel amp into 4 channel inputs of the subs?
link the 2 voice coils together on each sub then run a channel to one of the voice coils i believe…i havent wired subs in a couple years BUT BDR50H does it everyday so PM him he will give u the best answer
use the bridged outputs on the amp
ohhhh the amp went boooooom… I anyone got a 4channel amp that will make it much easier… oops
Buy a better 2 channel amp and follow the diagram dreid posted, or buy a 1 ohm stable monoblock amp and wire all 4 coils parallel to eachother.
I wouldnt suggest using a 4 channel. Most 4 channels dont offer low pass crossovers for all 4 channels, its usually low pass on just channel 3 and 4.