Engine Build

[draggone]

@KoukiS14

no its not a stroker, I dont need it. Just .20 over pistons thats it.

The turbo is a GT2871R .64 running 16-19psi. This block is overkill for the size of turbo but better safe then sorry.

The head was done at Headgames Motorworks in NJ and received a full port & polish good for 600hp supposedly. I am anxious to see whether this head paired with my turbo will provide top end gains and keep my midrange or kill it. I found the .64 to drop off a bit at redline but this setup could prove to remedy that.

Why run a small turbo like that on a fully built engine? You have an engine that can push out about 600hp or more depending on turbo and tunning and you are going to run a GT2871r.64.