Honda Linkage Pin Tool

anyone have one i can borrow for a few hours? i’d buy one but i know i’ll prob never use it again.

thanks

http://www.performanceforum.com/wesvann/honda/bitch/bitch.html

that or buy a roll pin punch (like 5 bucks)

lol sent him same link in pm. mine came right out with flat head in 2 hits. maybe i just got lucky :slight_smile:

↑ Nice link.

Use an air chisel if you have one. It worked quickest for Saxon and I last week. We tried a ton of things around the garage and like always it was a bitch but the air chisel took it right out.

i have a punch that fits perfectly for that pin. PM me if you wanna borrow it.

ive NEVER had trouble getting mine out with the correct size punch.

the punch size is 8mm i think, if you wanted to buy one

I had a nail set that I “machined” down with an angle grinder to 8mm. It worked decent.

But that link is awesome. I wish I had seen or thought of that at the time.

^^ I don’t think I’ve ever had one that was in there so tight that I had to really wail on it, I normally just have to tap them out. If it’s too much on the tighter side I crunch the pin down a little bit to loosen it up so its just snug, the surrounding clip prevents it from going anywhere anyways

although that link is definitely the more correcter way of doing it

404 Word not found in dictionary, lol…

Yea this pin is a bitch, but I didn’t have the right tool to get it out…

x2, its a 8mm punch

i thought so, the 8mm punch works perfect and its less than 5 bucks

got one today from 95d16turbo. thanks!

Jam I’ll txt you today, I sold the Supra and the guy wants to come pick it up tomorrow night, so I will be around if you wanna fight the axles and the bitch pin some more.