KKKustom exhaust at ASS (lots of pics)

[KrazyKid]

@DrunkieTheBear

I have a 3" downpipe. I just need a new one bend piece put in vs what I have now with is a U-bend more or less and it hangs really low. I scrape it everywhere I go and would like to have the U-bend taken out so I can go a little lower with coilovers.

Its a bit hard to explain but once you see it you understand, just a bad design on the headers. You’ll have to cut the Flex pipe section out on the rear bank weld in a piece to come straight down then a slight 75* bend into another straight.

You would have to do it with the header on the car, cause those things can’t come back off…but there is plenty of room to work worth from underneath. (those headers barely fit in that little cramped ass engine bay)

Sorry for threadjack

I am going to pull a ToughDbag1 here and say HOLY BIRD SHIT WELDS!!! That welder needs to turn up the heat and down on the wire speed!

anyways. with that V band in the way it makes things a bit harder. you would have to cut that off move it up higher, and make a better, tighter bend there. I see what your talking about though.

how about just slice a inch and a half off the bottom and weld a flat piece of plate back on! lol would cause a little choke point but who knows. :rofl

for real though. let me see what we can do.

EDIT, i see the flex section is up stream from the vband clamp there… i gotcha now.