rubbing issues

[trigger]

just installed my new megan racing coilover - great system btw.

I have it set on 10 clicks/14 clicks front rear (32 way adj).

I am rubbing in the front a little bit when I hit bumps and aggressive turning.

only about 1 finger between tire and the weather guard so i proceeded to take the whole weather guard off and the harness runs right over it. I tried playing around with it a bit to get it out of the way but no luck.

any suggestions on how to move it? i guess i can just raise the car a bit… or set it stiffer (10/14 is already pushing it on the street tho). thx

[SHIFT_KA24DET]

Relocate it to ontop of the fender support.

Remove the Fender and Ziptie it out of the way.

[Stock240]

What size tires R U using? I just bought these coilovers as well.

[boMex]

If you want to go low you will have to move the harness.

[SHIFT_KA24DET]

Remember though being low isn’t alway’s best.

You still want to be able to utilize full suspention travel…

[Sasha_SG]

@SHIFT_SR20DET

Remember though being low isn’t alway’s best.

You still want to be able to utilize full suspention travel…

I’d rather utilize your mom

[trigger]

stock240 - i still have my winter tires on for now… they are 205/55/16.

im going to take the fender off tomorrow… is it just simply take it off, put it ontop of the support and that’s it? Thanx.

[boMex]

I pulled the loom off the harness and re-wrapped it with electrical tape. I also pulled out some of the wiring that I wasn’t using to make the harness smaller. Then I moved it up and zip-tied it in place. You can slao hammer down the seam at the top of the fenderwell for another 1/2" of clearance.