u have a bead welded around the ends of the IC pipes?
sounds nice on that pull
looking good man, you ever drop that rear disc in that i sold you?
setup looks sick, t-clamps are a def not boosting above 10psi…check out swervemotorsports paul has different sizes and very resonable prices
:tup:
Justic Racing Engines did the machin work and
Prototype Engines did the assembly. Both did an outstanding job!
No I dont. But we will see if using better couplers and t-clamps hold up!
Not yet, Winter proj. they need alote of work, paint and new hardware first.
Paul’s hooking me up with some tires here shortly…Cant wait!
Here’s a teaser…
that is who has it… well if you need any parts for it let me know
and one of these weekends im going to swing out get the parts off ya
I really havent even looked at them yet… Yea LMK
The next chapter, Got this LS block almost ready to ship out to get sleeved!
Not sure what bore Im going with yet?
You’re fucking crazy, lol
nice dude! :tup:
open decks are gay as hell sleeved is the way to go
very nice cant wait to see it in person
gogo 84mm
if u just slap like two 1inch lines on opposing sides of the pipe then clamp it on, it’ll never pop off again
:word:
New shoes! 225 55 15’s
But I think I either have to raise the car up a little or get the fenders rolled. Something’s hitting over bumps?
:word: what did the car run
I don’t have an accurate answer for you yet. I did take this to the track a few weeks ago but I couldn’t get everything to work. I was getting use to the new 4 puck and when I did get a good start I would miss 3rd. It also felt like I was spinning and not getting anywhere. Im going up next week with the new tires. Ill post my times good or bad. I will say I trapped 118mph :gotme: